Not signed in (Sign In)

Vanilla 1.1.4 is a product of Lussumo. More Information: Documentation, Community Support.

    • CommentAuthorrruchi6
    • CommentTimeOct 10th 2017
     
    Hello,

    I am using KLayout 0.24.9 editor to draw structures as small as 5 micron for photo lithography masks. I am facing problems in copying structures from one layout to another layout.

    I have two different layouts with different "database units" (Layout 1=0.01 micron and Layout 2=5 micron). When I try to copy the structure from Layout 1 to Layout 2 the structure gets 500 times larger. (For example, 15 micron structure copied from Layout 1 is 7500 micron in Layout 2) So I tried to reduce the scale of the structure by 0.002 to match the original dimensions. In this case, the structural details gets distorted.

    Can someone please suggest, how can I overcome this issue?

    I know that I can draw the structure in the same layout but these structures take long time (which I don't have) to prepare. So I would like to know if someone has simple solution.

    Thanking you in advance.
    • CommentAuthorMatthias
    • CommentTimeOct 10th 2017
     

    Hi,

    I'd suggest to save Layout 2 in 0.01 micron database unit. Use "Save As" and on the "Save Layout Options" page enter a database unit of 0.01 micrometers (leave scale factor as 1.0). After that, you can safely copy & paste between both layouts.

    You can usually go to a smaller database unit without change of your drawing if the new DBU is a integer fraction of the original one. Picking a too small DBU only results in a limited layout area. The limit is imposed by the 32 bit nature of the (integer) coordinates. A practical limit is roughly -1E9 to 1E9 database units in each direction. With 0.01 micron, the usable area is 20 x 20m - that's a fairly big mask.

    If you are using the database unit to enforce your layout on a certain grid - the smarter option is to use grid snapping (File/Setup -> Application/Grid and Application/Default Grids).

    Regards,

    Matthias

    • CommentAuthorrruchi6
    • CommentTimeOct 11th 2017
     
    Thank you so much Matthias for the simplest solution and the explanation.

    Saving Layout 2 with "save as" worked perfectly for me. :)