Dunkelwind
About
- Username
- Dunkelwind
- Joined
- Visits
- 17
- Last Active
- Roles
- Member
Comments
-
Problem solved (after hours) . There are 2 overlapping poly layers. * poly Level TOP * poly Level Register6/SR3 the calculated layer (clk1SD) creates 2 polygons at different levels. therefore the extraction of MOS3 does not work. (Image)
-
Hi Matthias, clk1Gate.strict helps, the shapes are merged. But my initial problem is why are the calculated layers are placed to different levels. I use the hierarchical mode: deep...clk1Gate = active.overlapping(metalClk1) # select alle activ…
-
At the moment, the problem occurs again. My steps: * delete some shapes which are to be replaced by a cell * place cell * make cell variant * descending to cell * delete /move some shapes * ascending * message appears V0.29.2 Even when I am in T…
-
Here the setup. CLK2.oas is a helper layout with a cell NET_CLK2. All other cells are in the main layout, which is being edited Descend, edit and ascend I do for example in the cell Register0. This is where the problem comes in. (Image)
-
Yes, I have 2 layouts into one view. Is that a problem? This error happens quite often. But the program will not crash in this case. I can save and continue. So it's not a big problem.
-
After "descend" and editing the cell, I do "ascend" Following message appears: (Image) V0.29.1
-
Tnx Matthias, That's exactly what I need. Steffen
-
Thanks for pointing out the use of DRC. But when I debug my CustomExtractor, it would be good to find the faulty device. My idea was also that the extractor normalizes the shapes around 0,0.